To clean an aluminum lotion pump head, follow these steps:
Disassemble the pump head: First, remove the pump head from the bottle. Then, separate the pump head into its individual components. This will make it easier to clean each part thoroughly.
Rinse with water: Rinse each part of the pump head with warm water to remove any remaining lotion or residue. Use a gentle stream of water to avoid damaging the components.
Soak in soapy water: Fill a bowl with warm water and add a small amount of dish soap. Place the pump head components into the soapy water and let them soak for 10-15 minutes.
Scrub with a brush: Use a soft-bristled brush to scrub each part of the pump head thoroughly. Pay particular attention to the small crevices and hard-to-reach areas.
Rinse again: Once you have finished scrubbing, rinse each component of the pump head again with warm water to remove any remaining soap.
Dry: Use a clean towel or cloth to dry each part of the pump head. Make sure that all components are completely dry before reassembling the pump head and using it again.
English
简体中文
